• UV-tulostimella tulostat suoraan kappaleiden pintaan.
  • Rolandin uusin 4-väritulostin mallisto ammattilaisille
  • Supersuosittu tarraleikkurimme lyömättömään hintaan. Tutustu!
  • Rolandin uuden sukupolven leikkaavat suurkuvatulostimet
  • CO2 Laserkaiverrus ja laserleikkaus järjestelmät
  • Epsonin helppous ja laatu nyt DTG-tulotimessa.
  • Uusinta, nopeinta ja laadukkainta laserteknologiaa Epilogilta<br>
  • Rolandin uusi entistäkin nopeampi liuotintulostin
  • Tekstiilitulostamisen uusi aikakausi
  • CO2 Laserkaiverrus- ja laserleikkausjärjestelmät
  • Työpöydälle sopiva A4 koon kaiverruskone erinomaisella ohjelmalla. Vain 4700 €. Made in Japan

Permatex Fast Orange puhdistuaine 3,78l

Etusivu > LASERMATERIAALIT > Muut tuotteet

Permatex Fast Orange puhdistuaine 3,78l
Tuotekoodi
FAOR
Toimituskulut alk.
38,00 €
ALV 0,00 %
kpl

Soveltuu laserin poltossa syntyneiden palojälkien puhdistamiseen puupinnoilta.
Katso lisätietoja.

   


Easy Removal of Wood Residue

We often have customers contact us asking how we clean up our wood engraving samples when we're showing deep engraving. If you've ever run your laser at low speed and highpower, you've seen the results - sticky sap and varnish covering the areas you've already engraved. We wanted to share a product we've found that quickly cleans up all of that extra residue, leaving a clean, crisp engraving.

Using a common and easily accessible hand soap, we'll show you how to quickly and easily remove wood residue from any project. Additionally, the product we're using for this project is a biodegradable, waterless, petroleum solvent-free hand cleaner that contains neither harsh chemicals, mineral oils nor ammonia.

You'll need:

  • Permatex Fast Orange Hand Cleaner
  • Soft-bristle brush.
  • Paper towels or cloth.
 

Easily remove sticky wood residue by following the directions below.



 
1.

Begin by placing a small amount of cleaner on the brush. Then, gently scrub the area until it is free of residue.


 
  2.

When your project is residue free, simply wipe away any excess dirt and debris with a slightly damp paper towel.



 
   

And there you have it - a quick, effective and "green" way to remove stubborn wood residue from laser cutting and engraving projects.

 


Using the simple technique described above, our wood engraving looks crisp, clean and bright.

 
tech
tech

AAA-luokitus

3M

Roland

Epson

Epilog

Powered by Clover Shop® - www.clovershop.com