PVC heat seal material with polyester backing, created for inkjet digital printing and cutting systems with Roland eco-solvent inks. The material grants a high covering power on dark fabrics. Average film thickness before application:170 micron.
Soveltuu EcoSol MAX 2 musteelle,
Due to the many different base materials available on the market, the following instructions are given as a guideline only : Plotter settings (eg. with Roland VS-i) Blade: new at 50° | Minimum required pressure: 70 gf Transfer setup Temperature: 150°C | Time: 15” | Pressure: medium (3-4 bar)
Print and cut the material | Let the print dry at least 12 hours before rolling up, overlaying or heat transferring the material | Weed the exceeding material | Remove the print from the polyester backing using Roland application tape (adhesive, transparent and resistant to high temperatures) | Heat apply | Remove the application tape warm (should you use other application tapes, follow the manufacturer’s instructions)
Suitable textiles: Cotton, polyester and blends of these materials (not suited for treated and dye sublimation fabrics) Washing instructions: Wait 24h after the heat transfer | 50°C Max- inside out | Do not use bleach or other aggressive chemical agents. Dry clean: no | Tumble dry: not recommended
- Pesulämpötila: MAX 50°C - nurin käännettynä
- Ei rumpukuivausta
- Ei saa käyttää voimakkaita pesuaineita ( Emme suosittele huuhteluaineen käyttöä)
- Kemiallinen pesu kielletty
- Valkaisu kielletty
- Silitys nurin käännettynä
